Search models, users, collections, and posts
Tight and Secure Extruder Bowden Tube Clip Remix
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
5
5
0
0
11
3
Released
Description
I initially wanted a clip that was a bit more secure because my bowden tube kept coming unseated. I printed the original print from neolito, but that unfortunately did not help. I then purchased these bowden tube connectors and wanted to have the same connector, so here it is!
Print Recommendations
No supports
100% infill
Orientate model clip side down
Additional Parts Required
You will also need a small zip tie to secure the clip to the tube.
Print Settings
Printer Brand: Creality
Printer: Ender 3v2
Rafts: No
Supports: No
Resolution: 0.2 mm
Infill: 100%
Filament: SUNLU PLA
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)