Carp Leaping Over the Dragon Gate_Auspicious Fortune Seeking the God of Wealth

Carp Leaping Over the Dragon Gate_Auspicious Fortune Sending Blessing

• The overall design is in the form of a carp leaping from the water, the action is vivid, the bottom is a treasure basin with a beast head door ring, a week around the treasure basin is surrounded by peonies symbolizing wealth, which echoes with the surging waves in the middle, symbolizing blooming results and abundant wealth. The carp carries a Ruyi in its mouth and leaps up, also symbolizing auspicious fortune entering the house.
• A very delicate and auspicious ornament, one-piece printing, a must-have for stalls, a home decoration of choice.
• Initial configuration outer contour size: 77X74X126.8mm (Length X Width X Height)
• Due to the delicate and complex nature of the model, there are many supports, but the supports are set at large overhangs that are easy to remove. It should be no problem to remove them with a little patience, but it is recommended not to modify the parameters at will. It is also recommended that you remove the supports as soon as possible after printing is complete. The difficulty of removing the supports will increase after cooling.
• Using JAYO's PLA Silk Gold for testing, the printing effect is good. The initial configuration is 0.2 layer height, for high quality can be used 0.16 layer height, but note that the support may increase.
• Recommended materials: PLA, easy to remove support. PETG may be a little sticky, removing the support requires more patience.

3D Printing Techniques and Preparation Precautions

(Most models published by creators have been tested and can adapt to all models. Many times, printing problems occur, you need to check whether your printer and consumables are normal. This is a skill that you need to learn when playing with 3D printing. If you have any questions, you can also actively discuss them in the comment area, which is also the meaning of building such a community.)

Some notes are explained below. For more questions, you can ask customer service or check the Bambu Wiki, where you can learn a lot. Print Quality and Troubleshooting | Bambu Lab Wiki

• Make sure the print bed is clean. It is recommended to clean the print bed regularly! Grease residue on your hands after touching the printing panel will greatly reduce printing adhesion. At the same time, previous printing debris and small residual parts of the print will also affect the printing quality of the first layer, thus reducing the yield rate.
• Pay attention to drying the consumables, which will greatly affect your printing quality and printing experience! Consumables left for a long time will inevitably become damp. If there is stringing, it is recommended to consult the manufacturer for drying parameters to dry the consumables. At the same time, most manufacturers' consumables are not dried when they leave the factory. Therefore, the consumables we just unsealed are still a little damp, and it is also recommended to dry them before use.
• When using new consumables from the manufacturer, it is recommended to print the first time you use the consumables to calibrate the flow rate. This will greatly affect your printing quality and is a necessary process to allow the new consumables to adapt to your printer.
• If you encounter problems such as sudden decline in print quality and low yield rate, check if the nozzle is clogged, and you can also try to recalibrate the printer.
• Print at the recommended printing speed in the model description. Overhang quality is directly related to printing speed. The appropriate speed (too fast or too slow is not good) allows the material to have more time to cool and form when it is deposited.
• Set the heat bed and nozzle temperature according to the different materials. Too high or too low a temperature will cause warping, layer deformation or adhesion problems, thus affecting the print quality and success rate.