Search models, users, collections, and posts
Voronoi deer ornament
IP Report
Print Profile(6)
![[All Printers] Just a Brim: 0.2mm layer, 2 walls, 12% infill](https://makerworld.bblmw.com/makerworld/model/USc4b771ff158ccb/440277610/instance/2023-11-21_acc49ed409f6.jpg?x-oss-process=image%2Fresize%2Cw_100%2Fformat%2Cwebp)
[All Printers] Just a Brim: 0.2mm layer, 2 walls, 12% infill
2 h
1 plate
25cm X1C PLA 0.2mm layer, 6 walls, 25% infill manual support
7 h
1 plate
12cm high, 0.16mm layer, 2 walls, 100% infill
1.9 h
1 plate
18CM .2mm layer, 6 walls, 25% infill,Support
4 h
1 plate
Click to see more
Open in Bambu Studio
Boost
1392
3487
489
67
4.6 k
3.4 k
Released
Description
Most of the voronoi deer models were too big to my Kodama Trinus small print bed (120mm). Downscaling them made too thin walls, so I had to take a solid model, downscale and voronize it myself.
Should be fine without supports and add a brim to ensure correct first layer.
You might want to check the flat deer also ;)
A trend is emerging :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (489)