Search models, users, collections, and posts
Print Profile(2)
0.1mm layer, 1 walls, 100% infill
Designer
2.8 h
1 plate
0.1mm layer, 1 walls, 100% infill DISABLE DINAMIC FLOW
2.7 h
1 plate
Open in Bambu Studio
Boost
90
168
18
8
301
139
Released
Description
Content has been automatically translated.
This is a transparent cube printed following the Printing tips for transparent PETG | Bambu Lab Wiki guidelines. You can clearly see a starfish in the middle of the cube.
Notes
- At the very bottom there is a 0.4mm base, it is used to prevent the bottom surface from becoming cloudy when removing the model from the print plate. It's best to use PLA for this base, but you can also delete it if you are confident in your print plate.
- If using AMS printing, make sure the purge volume > 600. If not using AMS, you can also use the slicer software to set a pause to switch filaments. Remember to purge more.
- It is best to run a test according to the wiki above before printing. Pre-drying your PETG filament will significantly improve results.
- Do not enable flow calibration.
- It is not easy to achieve transparency with FDM printing, please treat it as a fun attempt.
Other crystals
Follow me, there are other beautiful crystals on my homepage.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (18)