Strainer for rice cooker

This is a remake of a simple strainer for a rice cooker pot.

With its small hooks on the right and left, as well as the holder at the back,
it sits securely in the pot and holds itself in place.

FaKe90 had designed the original so that instead of many small boxes,
long continuous lines could be printed.
However, this ability was lost in my remake.
https://www.printables.com/model/432212-ricecooker-strainersieve-reiskocher-sieve 

I printed in 0.20mm, standard quality in Cura,
which took almost 3 hours on my Sidewinder X1.

My pot has a diameter of Ø132.5mm and a sheet thickness of 2.0mm.
This is a cooker from Amazon: Arendo - rice cooker - 300 watts

The file will probably be inserted into the slicer in its original position,
here, of course, you have to turn it upside down.
I printed the little noses with support. But, in the middle at the back, it's quite fiddly to get it out again. 
Perhaps you can manage to print without support.

Enjoy!