Search models, users, collections, and posts
Wolverine Helmet Stand
IP Report
Print Profile(4)
AMS profile 0.2mm, 2 walls, 15% infill
2.9 h
3 plates
0.2mm and 0.24mm layer, 2 walls, 15% infill
2.4 h
3 plates
0.2mm layer, 3 walls, 15% infill, Generic Cylinder Stand
2.5 h
1 plate
Colored AMS 0.24mm , 2 walls, 15% infill
2.5 h
3 plates
Open in Bambu Studio
Boost
1518
3440
381
162
2.6 k
1.5 k
Released
Description
Recently printed out Deadpool and Wolverine masks and needed a stand. So I put this together.
You will need a 3/4 inch wood dowel cut to your preferred length.
Plaque - has a notch in it so it can be glued on the base at an angle. You can also glue it facing straight up on the base if you like. I paused the print for the color change on mine.
I did use supports on the notch in the plaque.
base-bottom.stl - This doesn't need to be printed unless you want the bottom covered. It is only 2mm thick so adjust the Z height in your slicer if you need it thicker.
Print Settings
- Printer brand: Longer
- Printer: Longer LK5 Pro
- Rafts: No
- Supports: Yes
- Resolution: .2
- Infill: 10
- Filament brand: Esun
- Filament color: Ruby Red
- Filament material: PLA
- Notes: I printed everything but the plaque at .28 to save some time.
Plaque was done at .2
Boost Me (for free)
Like what you see? Please consider boosting!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (381)