Search models, users, collections, and posts
1U 10 inch Power Brick Mount
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
6 h
1 plate
Open in Bambu Studio
Boost
271
1268
40
11
1 k
488
Released
Description
I made a little 1U tray to clean up the power bricks a bit, thought i'd post it just in case anyone else is need of a solution too. I made the zip tie holes a bit wide so they could fit larger power bricks. The image shows two ubiquiti bricks us-8 and us-8-60w. I would print this in PETG, 4-6 walls and 20-25% infill.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (40)