An absolutely cool 245 soldering station/iron integrating a 24V power supply and a sleep stand (all parts are readily available)

This model integrates the JBC245 soldering station control panel, 24V power supply and sleep stand in one, and also provides a place to place the soldering iron after it cools down. Make full use of the storage space.

1. First is the list:

      1.1 JBC245 control panel: It is basically suitable for the 8838 aluminum shell, as long as the panel opening is not too outrageous. The hole spacing is about 82*28    

      1.2 24V power supply: It is recommended to search directly on PDD and Taobao using image recognition. This kind of power supply is over-labeled, but it can easily run 100 watts for the 245

      1.3 Sleep stand: This one is quite universal, just search for 245 soldering station sleep stand

      1.4  Screws and others: 2 m2*(6~10) screws, any head will do

                                    m3*6               6 screws     cup head

                                   Nylon waterproof connector, size see picture, 1 cent each (generally applicable to cables)

                                   2-hole/3-hole wired plug, one piece

2. Assembly: Put the power supply in (it is strongly recommended to install the power supply with the heat dissipation hollow facing down to avoid metal splashes falling in), then insert the power supply pressure plate and fix the pressure plate with screws.

Remove the DC socket at the end of the sleep stand, pre-lead out the signal wires for sleep and head change (clamp on the steel shell), the wires go down from the rear hole. Then put in the sleep stand

Then cover the fixing plate and screw in 2 m2*(6~10) screws, any head will do.

Then it is all about wiring, fix the input wire with nylon connector,

Finally, cover the control panel and screw in 4 m3*6 screws

Congratulations, you now have an integrated and easy-to-store 245 soldering station!!!