Search models, users, collections, and posts
Star Wars Armada - Imperial Raider
Remixed by
IP Report
Print Profile(3)
0.4mm nozzle, 0.08mm layer, 2 walls, 15% infill
Designer
3.2 h
3 plates
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
Designer
4.5 h
3 plates
0.2mm nozzle, BRIM, 0.08mm layer height, 4 walls, 15% infill
Designer
4.6 h
3 plates
Open in Bambu Studio
Boost
155
511
32
12
417
198
Released
Description
I changed the original Model by Peacedemo (https://www.thingiverse.com/thing:6119208) to more accurately reflect the original Star Wars Armada Raider made by FFG.
The changes are as follows:
- Thickened all wings for better FDM printablility
- Extended the rear armor a bit to end at the same level as the main engine
- Changed the Angle of the bottom wing to be slightly more horizontal.
For printing I strongly suggest printing in two parts (split at the wing pylons) and then glueing together.
Otherwise the details on the back will get lost. For maximum detail I would also suggest using a 0.2mm nozzle, as the thin parts on the back and the details on the wings will mostly get lost with a 0.4mm nozzle.
Boost Me (for free)
Like this Armada Model?
Also check out my other models or leave a boost as a token of appreciation!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (32)