O11 Dynamic Evo Airflow Optimization Kit

Airflow optimization kit for Lian Li O11 Dynamic Evo. Includes gap covers for all major case perforations that's not a filter. Covers in pictures is from an ice cream box. Covers in model uses same dimmensions.

• Prevent air from exiting before passing through a radiator.
• Prevent recirculation.
• Help create overpressure to:
  • force more air through AIO radiator.
  • prevent dust sucked in.

I mounted them all using a hot-glue gun. Removable glue or double-sided tape recommended.

I run side + bottom as intake and rear + top including radiator as exhaust to create overpressure. I tried side with radiator but it didn't create overpressure. I only left the closest two PCI Slot covers to the GPU open, above and below. See picture.

I glued excessively to make sure no vibrations can occur and hot-glue is easy to remove anyway.

No support needed =)

Other mods:

I hot-glued the bottom fans in middle of bottom bracket to force more air into the GPU while preventing recirculation of air on inside next to MB. Put fans face down and lay bracket on top. Not much glue is needed and to be easier to remove. I also moved the top AIO fans to above the radiator to make it easy to clean at the cost of not seeing the RGB fans.

EDIT: I just changed top fan setup because I've designed a Through-fan PC Vacuum nozzle to be able to clean through fan blades and found different way to route tubes.

Also check out my O11 Dynamic Evo Riser Feet for +25 or +40mm clearance.

Hope you like it!