Shelf Stabilizer with Hole, Shelf Stabilizer, Shelf Fixed, Shelf Fixed Brace, Shelf Fixed Block, Shelf Shake Stopper, Shock Absorber, Shelf Stop, Shelf Stabilizer, Shelf Brackets

For those using shelves with holes, you can use this stabilizer to reduce shaking, one for each corner. If you haven't bought a shelf yet, remember! Don't buy one with holes for your printer, buy one with butterfly buckles!

Installation of this stabilizer is a little tricky, as it needs to be tight and have no gaps. You will need to use a hammer, and support the inside with a hard object. For installation, if you have a little handiness, just put in a little effort and you can install it. It's only about the effort of eating two steamed buns. Although it can't completely stabilize it, it does reduce the shaking a little.

The dimensions of my shelf with holes, the upright and the crossbeam, are shown in the picture below. You can use it as a reference. If you are unsure, just make one and try it out first. Shelves with holes are pretty much the same.

I'll say it again! For those who haven't bought a shelf yet, don't buy one with holes for your 3D printer, especially if you're like me and want to put more than one on it. If you're just storing filament or something, it's fine.