Search models, users, collections, and posts
IKEA Clothes Peg compatible with Pressa
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 20% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
28
67
35
15
150
113
Released
Description
Content has been automatically translated.
ATTENTION: AFTER PRINTING, THE CLIPS WILL SEEM BROKEN, MEANING THEY WILL NOT OPEN, BUT JUST A LITTLE FORCE IS NEEDED AND THEY WILL OPEN WITHOUT BREAKING
Clip suitable for IKEA Pressa, spare part that uses the original tension spring, simply detach the spring and refit it
Simple design to print directly that will last longer than the original part thanks to the joint and not a single piece that would break under the sun and water.
Dimensions:
width = 5cm
height = 1.1cm
hole diameter for spring = 3mm
Boost Me (for free)
If it was useful for you, use the Boost on me, thanks a lot
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (35)