F-22 raptor glider
Print Profile(4)
Description
Boost Me (for free)
:)
Are you looking for a fun glider?
Try out this F-22—it flies really well!
A few notes:
----------
CG = 4mm from the leading edge
----------
Make sure the pointy part of the "throwing handle" slots together.
---------
Glue is not necessary but recommended.
--------
Bend the wings up just past the side spars so that, if it's laying flat, the wing tips are 12 cm from the floor (not counting the "throwing handle").
---------
You may need to add some silly putty to the nose, depending on the filament used.
----------
there is a small Prime Tower, so the first layer goes down perfectly (circled in yellow)
----------
If you like it, don't forget to give it a boost and suggest a different airplane (SR-71, F-16... 🤔).
---------
if your interested plz check out my new Sukhoi SU-57 !!!!
Membership
Looking to sell my prints? take a look here -->
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1225)