Search models, users, collections, and posts
TD-H3 Skadis Holder
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
2 skadis hooks
22 min
1 plate
Open in Bambu Studio
Boost
25
65
5
6
65
31
Released
Description
I had way too many radio doo-dads on my desk, so I decided to print out some SKADIS clones and design a holder for my TIDRADIO TD-H3.
Features
- Holds the radio with battery attached
- Holds one spare battery
- Both sections have a slot for USB-C charging
- Can be printed without supports
You will need to print two SKADIS dovetail hooks from Tiggr. These should slide nicely into the slots on the back. If you want, you can add a drop of superglue to hold them in place, but I just leave them loose so that I can reuse the hooks on other projects if I want.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)