Custom Mounts for Maker's Supply hardware.

I will be using this as a place to store custom mounts I find useful for Maker's Supply hardware. It will be updated over time with new mounts created for projects that I think other designers/ makers might find useful. Starting off with the awesome single and quad LED boards, I've made 3 different mounts for each type. I can see these great little LEDs coming in very handy for a lot of designers, as they are bright and efficient in their space usage.

UPDATE 1.1

LA008 N20 WORM GEAR MOTOR MOUNT - 2 versions

LED BOARD MOUNT FEATURES

• Provide a secure way to mount these small LED's into your projects, making adoption into your designs easier.
• Both single and quad variants use m2.5 countersunk screws for mounting.
• Efficient space usage. No more or less material than is necessary for mounting.
• 3 Different designs for each LED. (single and quad boards) Different shapes/ mounting hole locations to suit a variety of applications.
• Push-fit, with the option to glue the boards in place to provide a long lasting hold.
• Each mount is 5mm in height, with the LED chip protruding around 1-1.5mm from the top of the mount.
• Each side of the screw holes are countersunk, should you wish to secure the mount on a specific side.

• Recesses in cable location help provide a firm, solid connection once installed.

  

LA008 N20 WORM GEAR MOTOR MOUNT FEATURES

• Two different mounting plates to suit different use cases.
• These mounts allow for the simple installation of a single LA008 N20 WORM GEAR MOTOR using 4 M2.5mm screws. 
• Cable through holes help with cable management and provide tidy routing. 
• The motor is held in place securely by a locking top plate, preventing it from coming loose under load.