Search models, users, collections, and posts
RC Car Wallmount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.5 h
2 plates
Open in Bambu Studio
Boost
61
163
7
2
134
61
Released
Description
this is a geometric styled wallmount for rc cars and the remote control. It's universal and can be adjusted in width. On the photo it's used for a hypergo 14210 truggy (scale 1:14). The measurement from the wall to the beginning of the hook is 16,5 cm. So if you measure your RC car from the outside of the wheel until the end of the baseplate, it should not exceed 16,5 cm. Otherwise you will have to scale
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (7)