Search models, users, collections, and posts
The Incredible Hulk
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
61
83
12
7
182
103
Released
Description
Content has been automatically translated.
It is recommended to use PLA material, with the support fully open at a threshold of 30. If you only support the key points, there will be defects in the crotch and chest areas. Use a water-jet pliers to cut off the supports.
Boost Me (for free)
If you think it's good, I need your support
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (12)