Wind Blown Puppy - Corgi (Sketchy Puppy)

Hi~

The Wind Blown Squad has a new member~ A short-legged Corgi~~

Their team is still growing~

Like my other models, it's still printed with white PLA filament. The difference is that other members of the Wind Blown family only need a little bit of color, but coloring the little Corgi is a difficult challenge.

I used brown-yellow soft-tipped acrylic markers to color the puppy's body and ears, black for the puppy's nose and eyes, red for the tongue, and pink for the ears. I left some of the white on the mouth and front of the body, in line with the colors of most Corgis in the real world.

Like the Golden Retriever with its tongue out, you only need to color the lips in black. Also, don't color the whole ear brown-yellow. It will look better if you leave a little white space around the pink earlobe and the outside of the ear. When coloring, leave space for the eyes, and after drawing the eyes with a black marker, wait for the black paint to dry before slowly filling in the space around the eyes with brown-yellow. Otherwise, the black will mix with the brown-yellow and it won't look good.

The model needs support, and the support is already set. When removing the support, it is recommended to first use a flush cutter to cut the support trunk and then slowly remove it. The support inside the mouth is not easy to remove, so pay special attention to the dog's tongue. Don't make it a 'mute puppy'.

If you like this series, you can check out my homepage, which has its other brothers and sisters. If you can give them a few boost coupons, they will be very happy!