Search models, users, collections, and posts
Cute Chubby Chipmunk
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 0% infill
Designer
9.4 h
2 plates
Open in Bambu Studio
Boost
3
11
0
0
7
5
Released
Description
A cute chubby chipmunk wearing a tophat, or not, it's up to you. If you print the version with a tophat, you will need to use supports for the brim of the tophat. I used organic supports, which were very minimal and worked very well. The version without the tophat can be printed without supports. I also printed with zero infill to save on filiment.
This is my first organic design and I know a few things are a bit rough (feet and hands are hard!), but I think it turned out really cute. This was based on a drawing that one of my kids did. Hope you enjoy!
Printed on: Ender 3
Material: Kingroon PLA
Layer height: 0.2mm
Supports: organic supports on tophat version only
Infill: 0%
Designed in: SolidWorks
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)