Search models, users, collections, and posts
Speedcube P2000 Pedal Footrest
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
8
33
0
0
58
15
Released
Description
Content has been automatically translated.
Speedcube P2000 Pedal Footrest.
Based on the original version,
- More mounting holes have been extended. Based on the selection of the original hole positions, it supports pushing the footrest towards the pedal until it touches the pedal.
- The height and width have been reduced. The tilt angle has been maintained.
It is cut into 2 pieces for printing, with snap-fit interfaces, and can be assembled and glued together after printing.
There are 3 10mm diameter holes left at the bottom, which provide height support for environments where height-increasing boards are used.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)