Wall bracket for NH00 fuse switch-disconnector

This wall bracket is for a 1-pole NH00 fuse switch-disconnector from Siemens (3NP11311CA10) and is used to guide the upper connection point downwards to save space.
If, for example, the fuse switch-disconnector is to be mounted next to a Victron Multiplus 2, the single wire (1x70mm²) to be connected at the top takes up too much space due to the minimum bending radius to be observed.
In this wall bracket, a 400mm long, laminated copper rail 5x20x1.0mm (e.g. from Rittal SV 3570.005) is guided downwards from the upper connection point.
This means that there is no longer a problem with the bending radius and a much more space-saving design can be achieved.
The following are required for this wall bracket:
8 x  M6 nuts (e.g. DIN934)
6 x  M6x40 countersunk head screws (e.g. ISO 14581)
2 x  M6x20 Allen screws (e.g. DIN912)
2 x  M6 washers (e.g. DIN125)
1 x  M8x30 hexagon head screw (e.g. DIN933)
3 x  M8 large washers 8.4x24.0x2.0mm (DIN9021 / ISO7093)
1 x  M8 spring washer (e.g. DIN127)
1 x  M8 nut (e.g. DIN934)