Search models, users, collections, and posts
Insta 360 x3 KingMa Charger housing
IP Report
Print Profile(1)
0.24mm layer, 3 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
6
13
0
0
7
1
Released
Description
Adapter created to allow charging while on the go. Using Kingma 3rd Party charger for the Insta360 X3 (https://www.amazon.sg/Insta360-Replacement-Battery-Charger-Cameras/dp/B0CLNJJ7H8) the print allows of holding the battery while having it in your bag to avoid dropping out of the charger or destroying the battery's connector when travelling.
Instructions. Place the charger into the base and cover it with the top piece, there are groves to guide the connection. I used super glue at the 4 corners of the print to keep them connected to each other.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)