Search models, users, collections, and posts
6.5 Creedmoor trim measuring 1.910 inches
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
9
17
2
1
28
19
Released
Description
A very quick to print trim length tool for the 6.5 creedmoor. This tool is set to min trim length of 1.910 inches. I got bored of measuring each case in the calipers, and refuse to spend £30+ for a shop bought trim tool, so ran this up quickly in tinkercad.
It takes around 25 minutes to print on the Bambu P1S and only uses 16g of filament, so its good if you have a bit left on a roll and want to use it up.
I printed this in PLA, but i dont see a reason why you couldnt print in PETG or others.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)