Rej3cted Wrkx

cover

IMG_9780.jpeg

IMG_9781.jpeg

Molle antenna clip v2.2

plate_1.png

2024-11-07_2c1f8f9fdb59b.jpeg

0.2mm layer, 4 walls, 25% infill

Backing Plate and All three Mounting Brackets at the same time Xtra Thick Backing Plate

Fabric Grommets for SMA connector

plate_2.png

Backing Plate Xtra Thick use M4 Bolts

plate_3.png

Standard Center mount (original)

plate_4.png

Left Of Center Mount (May Require Screw Trimming!!!)

plate_5.png

Right Of Center Mount (May Require Screw Trimming!!!)

plate_6.png

Cheeseburger

20260215_224331.jpg

Altered version of Original with Left of Center and Right of Center alternate mounting brackets.  I print these with a thick outer wall and several top/bottom layers at .08 with Sunlu PETG (Gloss) I wanted to see if I could shift the antenna over, to allow it to be braced by a clip on bracket on the molle Strap and allow me to mount the foldered antenna to the side. I made both versions because I wasn&#39;t sure what I will like better.

0.08mm layer, 5 walls, 15% infill

MOLLE Antenna Clip

The only change is the location of the mounting holes. I found it too difficult to get the panel in place and then attach the antenna.&nbsp;This allows it to be removed when needed without disassembling the entire thing!

MOLLE Antenna Clip V2.2

ASIA

Print Profile(2)

Description

Comment & Rating (13)

This remix is based on

License

Related Models