Rounded Gear Cube 50mm

The original gear cube was a bit large, and it had a lot of sharp edges, which made it a bit uncomfortable to play with.

So I tried printing a “non-sharp” version, which has a side length of 50mm, making it more suitable for playing with than my first version.

However, its method of dealing with sharp corners is simply using negative parts to cut off the top of the parts. Many sharp corners are not dealt with, and it is also slightly rough.

Also, perhaps to facilitate the sale of the product, its default configuration uses a higher layer height, making the layer lines slightly more noticeable.

So I made a rounded version based on this model, and the default layer height was changed back to 0.2, which made both the play and viewing experience better.