Meow! Do you have food on you? Right?

Meow! Do you have food on you? Right?

• This release is of a begging cat.

  Can be used as a desktop art piece, painted figurine, etc., with a single print and a short print time.

  Support removal difficulty 0 stars. I personally do not recommend continuing to shrink (I don't know what your consumables are like, I don't know what your machine is like. The materials are not much, you can try it.) Enlargement printing will definitely perform better.

  The printing material shown is Tianrui PEGT-EOC Milky White (It's been unpacked for a month and has become a little damp ). Try to use PLA to print, the effect will be much better

  Stringing and spaghetti during printing, surface unevenness problems please check the consumables. Please make sure to match your consumable temperature before printing. If you have any questions, you can discuss them in the comment area. Welcome to all the bigwigs to return pictures and comments! Thank you everyone!!!

• 3D Printing Tips and Precautions

• (All models released by this account have been tested for printing and can adapt to all models. Before printing, you need to check whether the printer and consumables are normal. If you encounter problems that cannot be solved, feel free to send me a private message, I will try my best to help solve them!)
• Note:
• If you encounter problems, you can go to Reference Learning Area: Print Quality and Troubleshooting | Bambu Lab Wiki
• Make sure that the machine printing plate is clean. It is recommended to wipe it with 95 degrees medical alcohol after each print, which can ensure stable printing quality and prevent overturning. Because touching the printing panel after the grease left on the hands will greatly reduce the printing adhesion, and at the same time, the small debris from the previous printing and the small residue of the printed parts will also affect the printing quality of the first layer, thereby reducing the product yield.
• Pay attention to consumable drying (PLA generally does not need to be dried, and the basic moisture resistance is good), which will greatly affect your printing quality and printing experience! Consumables placed for a long time will inevitably become damp. If stringing and spaghetti occurs, you need to ask the merchant to consult about the drying parameters and printing parameters to adjust, Most merchants' consumables are not dried before leaving the factory, so if you have the conditions, you can carry out pre-drying, and the printing effect will be better.
• The choice of printing materials, appearance parts generally choose PLA, structural parts generally choose PEGT, these two materials are relatively affordable and the volatilization of toxic gases is almost zero. (For health, it's best to have an air purifier running)
• When using new manufacturers' consumables, it is recommended to print on your hands immediately calibrate the consumable flow rate and modify the calibration coefficient, which will greatly affect your printing quality and is also a necessary process for new consumables to adapt to your printer.
• If you encounter a problem that the printing quality suddenly becomes poor and the product yield is low, check if the nozzle is blocked, check if the printer is placed stably (if it is stable, just put it directly on the ground) and you can also try to recalibrate the printer.
• Print at the speed recommended in the model description. The quality of the overhang, the number of surfaces of the model, and the printing speed are directly related , the appropriate speed (too fast or too slow is not good) allows the material to have more time to cool and form when deposited.
• Set the hot bed and nozzle temperature reasonably according to different materials. Too high or too low a temperature will cause warping, layer distortion, or adhesion problems, affecting print quality and success rate. For P1S and above models, if the temperature inside the user compartment exceeds 35 degrees, be sure to open the glass door on the fuselage.