Search models, users, collections, and posts
tape dispenser inner wheel replacement
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 30% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
37
92
15
3
238
136
Released
Description
Broken tape dispenser, this model appears to be quite generic (aka ihomecooker), inner wheel ends tend to break after a while, so Ive modelled a new inner ring piece as a replacement. (IVE INCLUDED AN IMAGE SHOWING PRECISE DISPENSER TYPE FOR YOU TO COMPARE, INNER WHEEL FITS INSIDE 2.6CM HOLE IN LARGER WHEEL)
ideally needs printing in pteg - didn't have any, so will see how long PLA will last
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (15)