Search models, users, collections, and posts
On Air - Lightbox
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.3 h
2 plates
Open in Bambu Studio
Boost
87
206
31
13
192
77
Released
Description
This is a very straight forward to print Lightbox. If you encounter any issues with pin-holes, up up your flow rate a small bit (I usually print at 0.98, but for lightboxes I print at 1.2-1.4 and it removes any pinholes).
In the current design I will be mounting this to a wall so have placed the cable hole on the base. If you could like to have the cable hole on the backplate, open the design in Bambu Studio or a slicer of your choice. You will see a negative cylinder cutting into the base. Simply move this to wherever you'd like the hole to be. Any questions, feel free to ask.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (31)