AAP-01 Belt Holster

I made this remix to make it easier to create this holster with as few screws as possible and above all to easily install it on belts without printing or buying other parts.

The holster is compatible with most simple belts available, I personally use it with a DEFCON5 strap belt.

You will only need a 6x17 spring (OD x Length) and a m3 x 20mm screw, even longer then decide if you want to cut it, you can use glue to keep the screw in place but honestly it holds very well even without it.

It only requires a little basic manual skill to remove the supports.
I recommend printing it with the back facing on the plate using normal supports only for the back and then remove them with a screwdriver or pliers.