Search models, users, collections, and posts
Bambu P1S Poop chute high walls Remix
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
11
35
20
6
156
113
Released
Description
A small adjustment to the poopbucket from 3D Printbit so that the left wall doesn't conflict with the filament with the default spool holder.
Only needed if you want the high walls and use the default P1S spool holder. See photo to see what I mean, with the original print you need to cut out a part.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (20)