Search models, users, collections, and posts
54mm Centrifugal Blower Volute
IP Report
Print Profile(3)
V1.0, default settings: 0.2mm layer height, 2 walls, 15% infill
Designer
4.7 h
3 plates
V1.1, default profile: 0.2mm layer height, 2 walls, 15% infill
Designer
3.2 h
4 plates
V1.1, Airflow Outlet (Separate): 0.2mm layer height, 2 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
56
96
2
1
93
2
Released
Description
Content has been automatically translated.
~~~~~~~~~~ Updated 2025-06-20 ~~~~~~~~~~
Added V1.1 profile configuration, update details:
- Adjusted internal air duct cross-sectional area to minimize air pressure leakage
- Reduced inlet diameter for a tighter fit with the blower fan
- Redesigned the blower base
- Assembly method changed to use 3 M3 x 5 mm screws
- Bottom changed to a hollow design for improved heat dissipation
- New slots for easier installation
- Added an air guide accessory to the outlet
Other notes:
- The new volute increases outlet air pressure to approximately 26 g (V1.0 was 24 g)
- The outlet air guide accessory can somewhat concentrate airflow, but will result in some air pressure loss
~~~~~~~~~~ Original Text ~~~~~~~~~~
Component assembly and fastening method: Adhesive, 1mm thick Magic Glue (only for V1.0 version)
Blower: 54mm diameter high-speed brushless turbine blower (12V) purchased from Taobao
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)