Sleigh Ban Christmas Glasses Multicolor Prop Toy

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

I was bored and decided to try to replicate my glasses, so I got to work in Tinkercad while I was messing around I remembered the Christmas theme contest and figured I would kill 2 birds with 1 stone.

So I came up with these Sleigh-Ban Sunglasses , a play on words of the famous original Ray Ban sunglasses.

Simple and quick multicolor print and you should be able to do a manual swap as I designed the color changes to be at the very top

The text is not the greatest just too small details for the .4mm hotend but you can try a .2mm and see if it improves, but for what it is i was satisfied.

Settings: Arachne walls, .20 layers, detect thin wall(checked), 15% adaptive cubic with infill combination(checked)

++Support not needed(do not use support it will fill in the hole on the frames and make it tough to get out, it will print fine without)++

++NOTE++ The arms may be a bit snug but if you wiggle them they should slide in, if not you may have to file the peg slightly until it fits, my right arm went right in but the left I had to work a little bit. Imay adjust the hole slightly larger, if too many have issues. I would put a drop of superglue in the hole so they will be more secure.