Search models, users, collections, and posts
HSW Bambu Plate Hook / Honeycomb Plate Holder
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
28 min
1 plate
Open in Bambu Studio
Boost
12
47
3
1
34
23
Released
Description
This is a low material way to hang Bambu plates from an HSW hexagon / honeycomb wall. Fits into common HSW inserts like those in the original profile: https://makerworld.com/en/models/22521#profileId-27457
Two lengths are provided so you could hang two plates over top of each other (slightly offset, as each hook will take up one hole in the HSW plate).
Note my picture shows the HSW hung 90 degrees from what is typical, because I hung mine up wrong. This posted model is angled for the correct orientation of the HSW (with a flat side up), not the wrong way like my wall.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)