Verm

cover

20250518_214619[1].jpg

20250518_214603[1].jpg

20250518_214756[1].jpg

20250518_214841[1].jpg

plate_1.png

Screenshot 2025-05-18 215847.png

This is a two piece version of the plate holder in PETG. This version has no supports. I made the top and bottom surface flat and with the two piece set up you get a nice texture on the outside of the plate that&#39;s consistent. The plate uses locating pins to make sure everything lines up nice and just needs some CA glue(Super glue). It might work without glue but I haven&#39;t tested it. I recommend the PETG version if it will be subjected to any real heat. Will need to use 2 plates if printing on the A1.

PETG Two Piece Ver. 0.2mm layer, 6 walls, 25% infill

This is a two piece version of the plate holder in PLA. This version has no supports. I made the top and bottom surface flat and with the two piece set up you get a nice texture on the outside of the plate that&#39;s consistent. The plate uses locating pins to make sure everything lines up nice and just needs some CA glue(Super glue). It might work without glue but I haven&#39;t tested it. I recommend the PETG version if it will be subjected to any real heat. Will need to use 2 plates if printing on the A1.

PLA Two Piece Ver. 0.2mm layer, 6 walls, 25% infill

moto plate holder.jpg

This is a one piece version of the plate holder in PLA. This version has supports and they may be difficult to fully remove. I made the interface distance bigger to try and make it easier to remove the supports. I made the top and bottom surface flat and with this new version. I recommend printing in PETG if it will be subjected to any real heat.

PLA One Piece Ver. 0.2mm layer, 6 walls, 25% infill

This is an 8 x 4 inch version of the cover for certain Canadian plates. I also used adaptive cubic for the infill to provide stronger lateral support. Highly recommend using PETG.Thanks!

8 x 4" Canada Version 0.2mm layer, 6 walls, 25% cubic infill

Envelope style license plate holder for motorcycles. Used and verified on a 2013 KTM 350 EXC-F in Utah. Might not work for all state&#39;s kind of plates. Please inform me of differences and I can make changes as needed. Thanks for looking.

Print Profile(4)

Description

Comment & Rating (14)

License

Related Models

Dirt Bike License Plate Holder (Envelope Style)

Print Profile(4)

Description

Comment & Rating (14)

License

Related Models