Search models, users, collections, and posts
Bambu A1+Mini Poop Basket+ holder slide joint
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
NEW 0.2mm layer,2 walls,15% infill, 2 support easy to detach
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
174
343
189
35
1 k
829
Released
Description
Content has been automatically translated.
*** New print profile!! ***
- Enhanced capacity and height (even smaller filaments are captured)
- Improved adhesion between the basket and the support
- It is possible to print only the new support (compatible with the previous basket)
It is possible to print only the new basket (compatible with the previous support)
The support requires adequate pressure for insertion and to ensure adhesion. Normally it is inserted and does not move anymore.
To remove the support I recommend moving the print head and then, using a screwdriver or lever, it can be removed without breaking anything (see picture).
Any suggestions for improvement are welcome.
Thank you
Slider implementation instead of magnets. If you don't have magnets you can use this model with a slider. Printing and installation are easy!
NB: The support includes a small part with support printing, to be enabled and printed; it's a beauty.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (189)