Search models, users, collections, and posts
80mm diameter steel ball storage tube, embossed texture (single layer 15x18 balls)
IP Report
Print Profile(2)
Version 1.0, no snap-fit design: 0.2mm layer height, 2 perimeters, 20% infill
Designer
5 h
2 plates
V1.2 Improved version, adding slots to the lid: 0.2mm layer height, 2 perimeters, 20% infill
Designer
6.3 h
4 plates
Open in Bambu Studio
Boost
3
12
0
0
14
6
Released
Description
Content has been automatically translated.
Considering the printing precision, picking up the last layer of steel balls might be a little difficult.
The combination of the lid and the handle requires the use of M3 screws and nuts, where the screw length should be greater than 7 mm.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)