Search models, users, collections, and posts
Rode Wireless go II TX(Mic) units charger
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
3
11
4
1
31
14
Released
Description
This is a remix of Marius Hornberger's work. Thank for his great design.
https://www.thingiverse.com/thing:4587047
He made the original model for Rode Wireless go.(1 TX and 1RX unit)
My RX unit is always mounted on the PC USB and TX and RX model's charging ports are not on the same plane, I could not charge both 2 TX units in Rode Wireless go 2 Package, so I arranged his model for 2 TX units.
In his Video, he recommended to use 2 x M3 30mm bolts and nuts for holding plugs but 2x 35mm bolts/nuts and 2 plastic screws for assembling are recommended on mine.
You can pick one model between low and full profile and print.
The Rode wind noise cutter can be used on low-profile model as below.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (4)