Fuzzy friend! Spin! Bounce! Humidify and purify!

Venonat sprites have arrived!

With the addition of a rotating air humidifier or purifier, you can even make them merrily bounce ~ Captivate the little ones for ten minutes or more :D

A plush surface has been deliberately employed to minimize the visibility of seams and layer imperfections on the spheres.

Four variants are available: large Venonat, small Venonat, bear ears, and cat ears—feel free to use any.

P.S. Venonat with ears are sometimes less inclined to bounce

P.P.S. Pay attention to the size of the air outlet to prevent injury to the Venonat

P.P.P.S. Printing Notes:

1. To reduce the likelihood of spaghetti strands and enhance the quality of the spheres, a raft and supports have been included in the configuration (adjustable depending on the material used)
2. PLA is used by default, and PETG is used for the raft and supports to facilitate removal and improve the surface finish of the spheres (can be modified if necessary)
3. Different raft and support parameters are employed for different sizes of Venonat
4. Be prepared for potential spaghetti issues when printing the spheres :D
5. Multicolor printing is slightly slower