Search models, users, collections, and posts
A1 / A1 Mini Christmas Antlers Decoration
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
20 min
1 plate
Open in Bambu Studio
Boost
26
36
5
0
50
38
Released
Description
A1 / A1 Mini Christmas Antlers Decoration
Wedges into the slots on the top of the A1 / A1 Mini hot end/tool head, the fit should be fairly tight, but will always depend on your printer, filament and calibration.
Ensure your hot end is cool before installing, support the tool head with one hand and wedge the bottom prongs of the antlers into the two slots found on the top of the A1/A1 Mini tool head, the A1 z axis will try to drop when you apply any pressure, the A1 Mini doesn't seem to but you should still support it during installation.
Inspired by A1/A1 mini Halloween Costume by Abenalbert
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)