Sexy Mrs. Claus Christmas Hueforge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Min Depth of 0.64mm
The Max Depth is 2.6mm and the Actual Depth is 2.6mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA Sunlu Meta White Transmission Distance: 8
PLA BambuLab Basic Silver Transmission Distance: 0.5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Red
At layer #16 (1.36mm) swap to White
At layer #22 (1.84mm) swap to Silver
At layer #25 (2.08mm) swap to White for the rest.

Even though the designer print profile has Bambu PLA Basic White in it, it's critical to use a high TD white, such as the Sunlu PLA Meta White (TD 8.0) that I've included in the above instructions. There are a lot of shades of red being generated in this print while still using only a single AMS, and it relies on the high TD white for color mixing. If you use something like Bambu PLA Jade White (TD 5.0), you won't get as many shades of red in the output, and the print will look whiter than it was meant to.