Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 3 walls, 70% infill
Designer
4.1 h
2 plates
Open in Bambu Studio
Boost
16
36
1
0
33
13
Released
Description
My Wife had the idea to take a 2000mm Tabletop and Cut it in two Parts so its the extension to her new height adjustable Office-Table. The Minimum height of the Table is 710mm. so i designed the Legs to compensate for the missing 25mm. The are designed to fit over the existing adhesive feet on the two Alex Cabinets. i mounted them in place with thicker doublesided tape, the will go nowere since there is some load on them. Also added some Felt for easy sliding arround.
Printed With esun Light PLA.
- No Brim
- 0.2 Layerheight
- No Supports
- 70% Infill for strength
- 2 Perimenters
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)