Govee Pro and Non Pro Mount Holder and Spacer

Edit 3:

After being up 20 feet in the air and testing myself, didn't have enough depth in the mount holder so I cut out the bottom and worked flawlessly.  No need to worry about depth of light and the mount will hold the light from falling through with their wire cut outs.  If you've already printed one, just cut out the bottom and it'll work just the same!

Using the two mounts I linked below will make for a more flush alignment, but as long as the mount fits in the hole, it should work for those mounts as well.  

Edit 2:

• Added a 2nd version that fits a pro mounting bracket
  • Deeper pocket and larger
  • Modeled to work with https://www.printables.com/model/630613-govee-permanent-outdoor-lights-pro-mounting-bracke/files
  • Slot holds up to 38.5x38.5mm bracket with a depth of 15mm
• Non Pro version adjust for deeper pocket 
  • Modeled to worth with Non Pro mounts designed by Toaaronmorris https://makerworld.com/en/models/110225#profileId-117810
  • Slot holds up to 37x37mm bracket with a depth of 7mm

Edit 1:

Added a version with a hole for attaching a hook or string so it doesn't fall off the ladder to the ground!

My hands were not liking trying to hold a 2x4, spacer, screw and mount at the same time on a ladder, plus I need to go 20 feet up for the next set of lights so I designed a spacer and mount holder in one. Lighter and easier to use.