Search models, users, collections, and posts
Exhaust Vent Cover
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
92
295
25
16
378
140
Released
Description
I made an exhaust vent cover used on a DIY BOFA filter unit used for laser engraving. This cover directs the exhaust air from the filter unit down, based on the direction it is installed.
This was made to fin a Dayton 1TDR3 Model Blower Motor, it may fit other similar models.
Dayton 1TDR3 Model Blower Motor: https://amzn.to/4a00uPq (As an Amazon Associate I earn from qualifying purchases)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (25)