Search models, users, collections, and posts
Desktop Wind Turbine Model
IP Report
Print Profile(2)
Basic print configuration, including a single-color impeller, decorative rings, and a plain undecorated base plate
Designer
4.8 h
4 plates
Modular version: 0.2mm layer, 2 walls, 15% infill
5.5 h
5 plates
Open in Bambu Studio
Boost
44
88
17
9
201
98
Released
Description
Content has been automatically translated.
This is a desktop wind turbine model that can be printed in a single color, or with additional color-printed decorative discs and separately colored blades. The central rotating shaft can be rotated manually, and may even rotate with sufficient wind (please avoid prolonged forceful blowing, it's harmful to health).
Because the blades and tower are vertically long and slender, a slower print speed was used. A single print uses 40g of material and takes 2 hours. Since the printed shaft is adhered at the bottom, it needs to be separated first. This print configuration provides two accessories for the initial twisting of the shaft, as shown in Figures 3 and 4.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (17)