Search models, users, collections, and posts
Gandalf the White Lightup Staff
Remixed by
IP Report
Print Profile(3)
0.16mm layer, 2 walls, 15% infill
Designer
8.5 h
3 plates
0.2mm layer, 2 walls, 10% infill
Designer
6.8 h
1 plate
0.2mm layer, 2 walls, 10% infill
8.5 h
3 plates
Open in Bambu Studio
Boost
96
226
26
14
266
138
Released
Description
Sharing a model i enjoy
found at https://www.thingiverse.com/thing:3114380
profile is setup exactly how i print. adaptive layer heights.
I currently have the infil set to lightning for the center crystal piece so when printed in clear filament has more of a gem effect.
You can also print it in vasemode to make it hollow.
The file is setup to allow for a light installation under the gem.
Do not use supports, it prints great just as it sets, just change the infill pattern.
I recommend turning off AUX fan for P1S users and setting chamber fan lower if you have the door open or the top off
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (26)