Hueforge Eye of Sauron LotR with The One Ring

This is my take on the Eye of Sauron with the One Ring coming out of the print. I found I didn't like vast amounts of dead space in the others I have seen, so I built this one from the ground up. This is sliced so that the ring will fit perfectly in the indentation of the HueForge. If you are using only one AMS system, make sure to add pauses where needed so that you can swap out filaments!

Instructions for the layer changes:

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.12mm

The Model is 228x228mm in size
You may print at higher layer heights below the Min Depth of 0.72mm
 

The Max Depth is 2.5mm and the Actual Depth is 2.5mm

Filaments Used:
PLA Overture Black Transmission Distance: 0.7
PLA Bambu Lab Maroon Red Transmission Distance: 2.5
PLA Inland true red Transmission Distance: 6.9
PLA PolyLite Orange Transmission Distance: 7.5
PLA Kingroon Orange Transmission Distance: 7.6
PLA Kingroon Yellow Transmission Distance: 7
PLA BambuLab Matte Ivory White Transmission Distance: 3.5
This print uses 7 unique filaments

Swap Instructions:
Start with Black
At layer #17 (0.76mm) swap to Maroon Red
At layer #18 (0.8mm) swap to true red
At layer #20 (0.88mm) swap to Orange
At layer #28 (1.2mm) swap to Orange
At layer #35 (1.48mm) swap to Yellow
At layer #44 (1.84mm) swap to Ivory White for the rest.