Search models, users, collections, and posts
Arrow Nock
IP Report
Print Profile(3)
0.2mm layer, 4 walls, 100% infill
Designer
34 min
1 plate
PLA, for pipe 5,6mm inner diam, 0.2mmlay,4 walls,100% infill
23 min
1 plate
PLA, for pipe 6mm inner diam, 0.2mmlayer,4 walls,100% infill
25 min
1 plate
Open in Bambu Studio
Boost
522
1195
46
19
1 k
608
Released
Description
Sometimes on our archery practice the nocks jump from the arrow when hitting the target. I usually can't seem to find them nowhere, so i decided to design my on nocks to print them when i lose one.
From the safety point it's always better to buy quality nocks in a store. I only used these in very low power bows.
I've uploaded a Step file of the nock so you guys can change to adapt to your arrow sizes.
Print with 100% Infill. PLA is too brittle. I found the ASA gives me best results in these.
Boost Me (for free)
If you enjoyed this model, please consider giving me a boost to support more creations. Keep printing and may your nozzles never clog. Thank you very much!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (46)