Print Profile(2)
Description
A decorative tealight holder with optional stand. Inspired by my plant pot with stand, using the same design.
The stand and pot are printed separately and easily fit together. The to pieces of the stand should slot together without the need for glue. A very small amount of support is used on the lower edges to improve the quality of the bevelled edge. Variable layer height is used to reduce the layer lines on the rounded edge.
I've made two profiles for printing, the standard profile will print on separate plates, and the other profile allows them to printed on the same plate with ‘print by object’ switched on. Therefore only a single filament change is needed and the model prints in under one hour.
If you like the design, then check out my plant pot with stand here:
https://makerworld.com/en/models/860078#profileId-810165
Or here:
https://makerworld.com/en/models/869828#profileId-821600
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (66)