LEG0 Like Brick Minifigure Display Stand
Print Profile(2)
Description
I have been using the official LEG0 ones and have been annoyed by the loose fit of minifigures and them falling over.
This has a tighter fit and should allow figs to sit snugly on your display (I tried to find a compromise between too much stress on the legs and a snug fit). Tested in PLA and PETG. No support is needed.
Two versions: “Looser Tolerance” which is tighter than stock but very conservative if you are worried about expensive figures and the standard one which is nice and snug.
The print profile has two plates, one print by part and one print all at once, if you are worried about stringing use the print by part one.
Boost Me (for free)
Boost me for free if your minifigs found a new home
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (31)