Search models, users, collections, and posts
Magnetic Door Hold
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
22
74
1
2
74
41
Released
Description
Boost Me (for free)
If you found this model useful, consider boosting me to help support future projects!
Inspired from the QMD door stopper. Not exactly a remix, but I liked his design, so I drew a similar one.
- Supports door gap (floor to door bottom) from 10mm to 35mm
- uses 10x3mm magnets
You can use some CA glue to hold the magnets in place if they are not inference fit tightly
use double sided tape to glue to your door/floor
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)